ARCHITECTURE

The best safeguard solutions
for your cathodic protection system

The technology proposed by AUTOMA for the monitoring and remote control of the cathodic protection system is based on devices, data loggers and RTU of the family GOLIAHxC that implement the most modern measuring techniques of IRFree potentials on coupons to ensure a 

continuous detailed verification of the cathodic protection effectiveness. These technologies are managed and governed by SCADA by AUTOMA, in the WebProCat section, which offers a wide range of analysis and reporting tools dedicated to cathodic protection.

Solutions

MONITORING

Cathodic protection remote monitoring
  • Guaranteed 24-hour monitoring with high-frequency sampling (1 per second);
  • Precise and accurate measurement of ON potential and OFF potential at all measuring points;
  • IRfree potential measurement on coupon, essential in areas with stray currents and on all cathodic protection systems where synchronised interruption of cathodic protection T/R is difficult or impossible;
  • Measurement of current signals with shunt and other voltage measurements (T/R current and output voltage, current in drain, etc.);
  • High autonomy in the field with both battery and auxiliary power supply to ensure correct operation even in the event of an external power failure;
  • Real-time monitoring on externally powered devices.
Devices

G3D, G4C, G4C-PRO, G4D-PRO, G4F

Accessories

BOX SOLAR

Cathodic-protection-monitoring-with-operator
  • Precise and accurate measurement of ON potential and OFF potential at all measuring points;
  • IRfree potential measurement on coupons, essential in areas with stray currents and on all cathodic protection systems where synchronised interruption of cathodic protection T/R is difficult or impossible;
  • Measurement of current signals with shunt and other voltage measurements (T/R current and output voltage, current in drain, etc.);
Devices

G4O

REMOTE CONTROL

Remote control of cathodic protection rectifiers
  • Remote configuration of cathodic protection T/R operating parameters:
    • Interface by signals 0-10 V and/or 4-20 mA;
    • Interface RS485 with communication protocols (ModBus, AEMT, etc.);
  • Cathodic protection dynamic regulation with AI algorithms:
    • Regulation according to local measurements;
    • Regulation according to remote point measurements;
    • Regulation according to the measurements of the cathodic protection system.
Dispositivos

G3D, G4C, G4C-PRO, G4D-PRO, G4F

Accessories

BOX SOLAR

SYNCHRONISATION

Cathodic protection rectifiers synchronised ON/OFF
  • Cycling interruption of T/R;
  • GPS synchronisation;
  • Cycling interruption for CIPS and DCVG analysis
Devices

G4C-IBK

Our products

G4C-PRO

INFO SHEET

G4O

INFO SHEET

G4D

INFO SHEET

G4C-IBK

SNODE

BOX SOLAR

G2P-VCTRL

error: Content is protected !!